FREE Shipping on orders over $100 (except where noted)

Snap Togglers - Stainless Steel

Snap Togglers
SNAPTOGGLE heavy-duty toggle bolts carry twice the load in a smaller hole than standard wing anchors. A new, patented strap design with sturdier straps and smaller ratchet interval adjusts more precisely and snaps off flush to the surface. SNAPTOGGLE heavy-duty toggle bolts do NOT spin when installed with a screw gun and provide superior holding with metal-to-metal fastening.
Installation Instructions:

SNAP Toggler Install1 | The Nutty Company, Inc.
Drill appropriate size hole. Hold metal channel flat alongside plastic straps & slide channel through the hole. Minimum clearance behind wall: only 1-7/8".

SNAP Toggler Install2 | The Nutty Company, Inc.
Hold ends of straps together between thumb & forefinger and pull toward you until channel rests behind wall. Ratchet cap along straps with other hand until flange of cap is flush with wall.

SNAP Toggler Install3 | The Nutty Company, Inc.
Place thumb between straps at wall. Push thumb side to side, snapping off straps level with flange of cap.

SNAP Toggler Install4 | The Nutty Company, Inc.
Place item over flange. Insert bolt and tighten until snug against item, then stop. Use machine screw or bolt to match thread in metal channel.
Showing 1 - 4 of 4

Don't see the length/diameter/what you're looking for?

Request A Quote