-
3/16 X 1-1/8 Lynch Pin
SKU: LP316
$0.590each -
1/4 X 1-1/4 Lynch Pin
SKU: LP14
$0.690each -
5/16 X 1-1/4 Lynch Pin
SKU: LP516
$0.790each -
7/16 X 1-7/16 Lynch Pin
SKU: LP716
$0.890each
Lynch Pins

Lynch Pins
Lynch pins, also called linch pins or PTO lynch pins, are quick-release locking pins with a spring steel ring. Push the pin through the hole in a shaft, axle or hitch pin, then swing the ring down over the end of the pin until it snaps in place. The ring keeps the pin from backing out under vibration, and it comes off by hand in seconds with no tools.
Specifications
- Pin diameters: 3/16", 1/4", 5/16" and 7/16"
- Usable lengths from about 1-1/8" to 1-7/16" (see the data sheet for exact dimensions and tolerances)
- Pin: mild (low carbon) steel
- Ring: spring steel wire
- Finish: yellow zinc plated for corrosion resistance
Common Uses
- PTO shafts and drivelines
- Hitch pins, top link pins and three-point hitches
- Tractor, mower and lawn & garden implements
- Trailer axles, wheels and removable brackets
- Farm, construction and marine equipment
FAQ
How do I choose the right size lynch pin?
Match the pin diameter to the hole in your shaft or pin, then make sure the usable length (from under the head to the inside of the closed ring) clears the part the pin passes through.
How do I install a lynch pin?
Swing the ring up, push the pin through the hole, then fold the ring down over the end of the pin until it snaps around it. To remove, pull the ring back over the pin end and slide the pin out.
Lynch pin vs. R-clip: which should I use?
Both are quick-release and reusable. A lynch pin goes through a hole in a shaft or axle and locks with its ring, while an R-clip goes through a cross hole in another pin. Lynch pins are a common choice on PTO shafts and wheel axles.
